The CJ3A Page CJ3B.info

Post reply

Warning: this topic has not been posted in for at least 120 days.
Unless you're sure you want to reply, please consider starting a new topic.

Note: this post will not display until it's been approved by a moderator.

Name:
Email:
Subject:
Message icon:

Verification:
Type the letters shown in the picture
Listen to the letters / Request another image

Type the letters shown in the picture:
Write the word between words Jeep from this JeepWILLYSJeep?:
How many slot has a GPW grill?  7 - 9 - 11:

shortcuts: hit alt+s to submit/post or alt+p to preview


Topic Summary

Posted by: Lee
« on: April 15, 2014, 08:35:01 PM »

Head bolts are in the same places, I recommend studying the gaskets before installing one, LOL, I installed a F head gasket in an L many years ago by mistake, results are NO compression and lots of bad language ;D

Lee ;)
Posted by: Jesse
« on: April 15, 2014, 01:41:09 PM »

Hmm right I was thinking about the head bolts as well. Didn't think about the pushrod guides.

-Jesse
Posted by: johnrb3b
« on: April 15, 2014, 01:31:16 PM »

Too many differences.
Pushrod guides for the intake valves in the head.
Manifolds
I don't know if the head bolts are in all the same places. Probably not.
Probably lots more I don't know about.
Posted by: Jesse
« on: April 14, 2014, 07:54:28 PM »

Hey guys,

Just doing a little keyboard wrenching tonight, and I was wondering if anyone could point out the real differences between an L and F head jeep block. Did the F head blocks still have the places for the old valves blocked off? I know they casted them without intake ports on the drivers' side. What other changes were made? Couldn't you just put an F head on an L engine?

If you could, it seems like more people would go for it so maybe it isn't possible...

-Jesse