The CJ3A Page CJ3B.info

Post reply

Warning: this topic has not been posted in for at least 120 days.
Unless you're sure you want to reply, please consider starting a new topic.

Note: this post will not display until it's been approved by a moderator.

Name:
Email:
Subject:
Message icon:

Verification:
Type the letters shown in the picture
Listen to the letters / Request another image

Type the letters shown in the picture:
Write the word between words Jeep from this JeepWILLYSJeep?:
How many slot has a GPW grill?  7 - 9 - 11:

shortcuts: hit alt+s to submit/post or alt+p to preview


Topic Summary

Posted by: Ryan_M
« on: March 29, 2014, 11:15:40 PM »

This does not have the specific answer you are looking for but it does have some other pretty handy torque specs:

http://www.cj-2a.com/techtips/specs/torques.html
Posted by: Mike S
« on: March 29, 2014, 10:50:44 PM »

In the Willys service manual you will find the torque specifications for engine and chassis on page 275 - table U55.

I think the crankshafft pulley nut is like 180 - 200 lbs./ft.? Not sure however.
Posted by: ZekeD
« on: March 29, 2014, 04:03:36 PM »

Yep!   I read the book, got me to the same place ;D

Zeke
Posted by: 1955CJ-5
« on: March 29, 2014, 02:57:40 PM »

The book says to install the pulley and tighten the nut!! Pretty informative....

There must be a number somewhere....2a site maybe?
Posted by: ZekeD
« on: March 29, 2014, 02:31:08 PM »

Is there a place where the torque values are listed for the L engine?  I tried searching the forum but didn't fine anything.

Specifically is there a number for the crankshaft pulley nut?

Thanks

Zeke in Oregon