The CJ3A Page CJ3B.info

Post reply

Warning: this topic has not been posted in for at least 120 days.
Unless you're sure you want to reply, please consider starting a new topic.

Note: this post will not display until it's been approved by a moderator.

Name:
Email:
Subject:
Message icon:

Verification:
Type the letters shown in the picture
Listen to the letters / Request another image

Type the letters shown in the picture:
Write the word between words Jeep from this JeepWILLYSJeep?:
How many slot has a GPW grill?  7 - 9 - 11:

shortcuts: hit alt+s to submit/post or alt+p to preview


Topic Summary

Posted by: Gunslinger
« on: March 29, 2014, 10:01:38 AM »

Thank you sir!
Posted by: Bob W
« on: March 29, 2014, 07:34:40 AM »

The Bestop Tigertop instructions have the dimension that seems to be accurate.

http://www.bestop.com/images/installation_guides/51403.pdf

"Measure and record the distance from the top inside edge of the windshield to the rear inside edge of the vehicle body, not the tailgate. Take the measurement from approximately six inches inside the vehicle�s doors. Check to make sure that both sides measure equally. To install this top properly, this measurement must be 66 1/2 inches"
Posted by: Gunslinger
« on: March 28, 2014, 09:40:09 PM »

Anybody remember what the dimension is from the top of the windshield to the rear of the body?  Diagonal dimension?  I'm trying to figure out how far rearward my windshield is canted.
Thanks