Posted by: Carls_jeep
« on: March 12, 2014, 11:47:33 PM »Be sure you have the same amount of shims on each side. You have to put the cover plate and backing plates on to measure the end play. Then as Bob said, smack each axle with a dead blow hammer and then measure the end play. It should be .005" to .007".
The shims and cover plate space the backing plate away from the axle housing and the outer bearing race will fit inside the shim ID. When you smack the axle it pushes the outer race out past the shims against the cover plate. The spliced end of the axle rides against a block in the carrier assembly and the block is limited in how far it can slide from side to side and is the reason for equal shims on each side, or as equal as you can get them. Preferably within a few thousandths.
The shims and cover plate space the backing plate away from the axle housing and the outer bearing race will fit inside the shim ID. When you smack the axle it pushes the outer race out past the shims against the cover plate. The spliced end of the axle rides against a block in the carrier assembly and the block is limited in how far it can slide from side to side and is the reason for equal shims on each side, or as equal as you can get them. Preferably within a few thousandths.