The CJ3A Page CJ3B.info

Post reply

Warning: this topic has not been posted in for at least 120 days.
Unless you're sure you want to reply, please consider starting a new topic.

Note: this post will not display until it's been approved by a moderator.

Name:
Email:
Subject:
Message icon:

Verification:
Type the letters shown in the picture
Listen to the letters / Request another image

Type the letters shown in the picture:
Write the word between words Jeep from this JeepWILLYSJeep?:
How many slot has a GPW grill?  7 - 9 - 11:

shortcuts: hit alt+s to submit/post or alt+p to preview


Topic Summary

Posted by: Ryan_M
« on: February 28, 2014, 11:49:40 PM »

I had mine re-cored at a shop. The new core is about an 1/8"-1/4"  shorter than the original but it works fine now.
Posted by: 1955CJ-5
« on: February 28, 2014, 10:44:25 PM »

That seems to be the area where this one is leaking.....I'll pull it out again and take it back to the shop....
Posted by: garage gnome
« on: February 28, 2014, 10:36:28 PM »

Mine were cracking where the two tubes go into the core. I finally got that problem sorted out.
Posted by: 1955CJ-5
« on: February 28, 2014, 10:12:47 PM »

Well, this is getting frustrating, and it's a purely useless exercise anyway...what use is a heater if you don't have a top?

But, I've had it out and repaired three times, and each time it works for a short time and starts to leak again.....probably work hardened beyond hope...

Is there a source for replacement cores? It's the roughly 4" by 16" core..

Anyone have any experience with this?

It's bypassed for now....and it may remain that way....