The CJ3A Page CJ3B.info

Post reply

Warning: this topic has not been posted in for at least 120 days.
Unless you're sure you want to reply, please consider starting a new topic.

Note: this post will not display until it's been approved by a moderator.

Name:
Email:
Subject:
Message icon:
Verification:
Type the letters shown in the picture
Listen to the letters / Request another image

Type the letters shown in the picture:
Write the word between words Jeep from this JeepWILLYSJeep?:
How many slot has a GPW grill?  7 - 9 - 11:

shortcuts: hit alt+s to submit/post or alt+p to preview


Topic Summary

Posted by: garage gnome
« on: February 03, 2014, 01:12:31 PM »

Yep, as Ryan posted, R&Ps kits works great. I did Herms on my 53, but if I was to do it again, I would use R&Ps kit. Much easier to install. There is a link a few pages back in that thread to purchase the kit.
Posted by: Ryan_M
« on: February 03, 2014, 11:24:53 AM »

Check out page 8 of GarageGnome's project. He shows a pic of an installed dual MC that clears the tub.

http://www.cj3apage.com/cgi-bin/yabb2/YaBB.pl?num=1364006201/118#118
Posted by: ZekeD
« on: February 03, 2014, 10:42:14 AM »

I want to go to dual master cyl on my '49 CJ3 and I have the tub off of the chassis, and the rolling stock is almost finished.  I can route the lines, but is there interference with the tub caused by the larger MC?

Zeke. ( making progress )