The CJ3A Page CJ3B.info

Post reply

Warning: this topic has not been posted in for at least 120 days.
Unless you're sure you want to reply, please consider starting a new topic.

Note: this post will not display until it's been approved by a moderator.

Name:
Email:
Subject:
Message icon:
Verification:
Type the letters shown in the picture
Listen to the letters / Request another image

Type the letters shown in the picture:
Write the word between words Jeep from this JeepWILLYSJeep?:
How many slot has a GPW grill?  7 - 9 - 11:

shortcuts: hit alt+s to submit/post or alt+p to preview


Topic Summary

Posted by: Bob W
« on: January 20, 2014, 11:18:40 AM »

Looks like a CJ-5 starter.
Posted by: Jeff_M
« on: January 20, 2014, 07:10:18 AM »

I agree with Tim in that a 24v probably wouldn't work in a 12v system.  In addition, I've heard that starter work and it spins the engine over well.  It's most likely a replacement. 

Posted by: athawk11
« on: January 19, 2014, 11:08:23 PM »

Ryan, I know you can use a 12v system with a 6v starter, but I don't think a 12v system could deliver enough power to a 24v starter.  Does the starter turn strong, as is?  If so, it's probably a 12v starter.

That said, I don't what you have.  It doesn't look anything like the starters I have.

Tim
Posted by: Ryan_M
« on: January 19, 2014, 09:07:28 PM »

I pulled this starter of my M38. The tag is gone but it's marked "PS3111". I can't find anything conclusive enough in my web searches to know what it is. I also don't know a lot about starters in general. An M38 was originally 24V. Mine is now 12V. Aren't these starters voltage specific? Or can you keep the same starter at 6, 12, or 24V?

This one has a couple holes where either a solenoid was mounted or could have been mounted. There is no band around the rear. Should there be? I'm trying to figure out what this is and if it's likely to be original.