The CJ3A Page CJ3B.info

Post reply

Warning: this topic has not been posted in for at least 120 days.
Unless you're sure you want to reply, please consider starting a new topic.

Note: this post will not display until it's been approved by a moderator.

Name:
Email:
Subject:
Message icon:
Verification:
Type the letters shown in the picture
Listen to the letters / Request another image

Type the letters shown in the picture:
Write the word between words Jeep from this JeepWILLYSJeep?:
How many slot has a GPW grill?  7 - 9 - 11:

shortcuts: hit alt+s to submit/post or alt+p to preview


Topic Summary

Posted by: ZekeD
« on: January 12, 2014, 11:21:26 AM »

Where do you get an elliptical drill bit?

Zeke
Posted by: 1955CJ-5
« on: January 11, 2014, 11:19:09 PM »

Glad to help! My jeep is about 15 steps away, and it's too cold to drive it, so I may as well measure it :D
Posted by: Steve
« on: January 11, 2014, 10:23:09 PM »

Thanks a bunch!
Posted by: 1955CJ-5
« on: January 11, 2014, 09:17:54 PM »

Elliptical is correct..!

I could not get a good picture with the pedals in place, but the holes themselves measure 1.25 by 1.52"...give or take a little!
Posted by: Steve
« on: January 11, 2014, 08:53:15 PM »

Tomorrow is the day that I am going to cut the floorboard holes in the new tub. I have the old tub to use as a template; however, the holes for the clutch and brakes are ellipsis rather than circles. I suspect that they should be circles, am I correct?
If so, does anyone know the distance from the bottom floor bend to the center of each circle? Thanks.

Steve