Posted by: Steve
« on: October 21, 2013, 10:33:33 PM »Thanks guys. The quality and volume of help and suggestions from the members of this site is awesome.
Steve
Steve
Welcome to our new forum software.
We are now using SMF instead of YaBB.


Those pictures are very helpful. Rather than purchase floors, I think that I may try your tracing approach..� A few questions:1.They are spot welded in. Either get a spot weld cutter or drill out the welds from underneath. Id remove the whole floor with lip. That way you wont have to deal with welding in that whole edge.
1. I have to cut out the floor. Should I cut flush with the sides, or leave the lip? If I leave the lip, I am going to have to separate the old floor from the sides. Not sure if it is a continuous or spot weld.
2. What is the dimension (height) of the bend of the floor panel?
3. What did you use to cut out the floor to get such nice, straight cuts?
4. Where do you weld the floors to the side panels? Underneath, or at the top where the floor meets the side panel?
Thanks.
Steve






If you have a choice and want to, step it up to 16 gage, same for the hat channels.