The CJ3A Page CJ3B.info

Post reply

Warning: this topic has not been posted in for at least 120 days.
Unless you're sure you want to reply, please consider starting a new topic.

Note: this post will not display until it's been approved by a moderator.

Name:
Email:
Subject:
Message icon:
Verification:
Type the letters shown in the picture
Listen to the letters / Request another image

Type the letters shown in the picture:
Write the word between words Jeep from this JeepWILLYSJeep?:
How many slot has a GPW grill?  7 - 9 - 11:

shortcuts: hit alt+s to submit/post or alt+p to preview


Topic Summary

Posted by: athawk11
« on: September 30, 2013, 12:03:09 PM »

Looks like Pete Debella may have what you're looking for.� I would call to confirm that this unit would not ubstruct the PTO shaft.

http://www.debellajeepparts.com/mbgpwexhaust.htm

Tim
Posted by: ZekeD
« on: September 30, 2013, 11:33:03 AM »

I was trying to keep the muffler protected by the frams and not hang down.    The military answer is like the picture.   I was hoping someone made a ready to install unit.
Posted by: Quebec Jeep
« on: September 30, 2013, 08:08:30 AM »

here is how Jonathan did it:

http://www.cj3apage.com/index/My_1950/installing_a_pto_winch.htm
Posted by: ZekeD
« on: September 29, 2013, 09:49:50 PM »

I have seen pictures of an alternate route for the exhaust and muffler when you have a front PTO.   Mine runs under the trans suport bracket, and goes all the way back.  The alternate crosses behind ? The bell housing and exits in front of the passenger's rear wheel.    Do you know if anyone sells a premade setup for this?

Zeke in Oregon