The CJ3A Page CJ3B.info

Post reply

Warning: this topic has not been posted in for at least 120 days.
Unless you're sure you want to reply, please consider starting a new topic.

Note: this post will not display until it's been approved by a moderator.

Name:
Email:
Subject:
Message icon:
Verification:
Type the letters shown in the picture
Listen to the letters / Request another image

Type the letters shown in the picture:
Write the word between words Jeep from this JeepWILLYSJeep?:
How many slot has a GPW grill?  7 - 9 - 11:

shortcuts: hit alt+s to submit/post or alt+p to preview


Topic Summary

Posted by: Bruce_W
« on: September 07, 2013, 10:34:46 PM »

  That's what I use, and have for years - a little #2 on the outside, not only to help it seal, but to help it slide into place. And lubricate the rubber part with whatever lubricant the seal is there to hold.    BW
Posted by: PaulS
« on: September 07, 2013, 08:32:39 PM »

Do you use any sealant when installing new seals?  I know the Moses Ludel book suggests using Super 300, but I couldn't find it anywhere...  I have a tube of Permatex #2, which I think might be similar (both being non-hardening "Form-A-Gasket" products).

Do you use a sealant when installing new seals?  If so, is the #2 acceptable for this use?

Thanks,

-Paul