SUCCESS moved the oil pump drive gear over two teeth now it runs like it was supposed to timing adjustment is in the center of the adjustment slots finally were ready to roll in the parade.
Solved the stumbling problem with the jeep yesterday I bought a new distributor the engine runs good now through acceleration but the timing issue still remains. I have no timing marks anywhere on the engine so I brought #1 cylinder to TDC and scribed some on the timing gear cover and pully. When useing a timing light there is a one inch gap between the marks timing is retarded and no adjustment left with the distributor. Today I am going to remove the oil pump and move the drive gear a tooth th get more timing adjustment. The old distributors advance weights werent working as they should and this distributor has the electronic ignition already built in its a pretty nice unit $125 shipped to my door.
Im still at an impass with my distributor mine is the later version pictured the springs on the advance weights seem pretty stiff. I wonder if they use the same spring maybe that is the problem if you gun it the engine takes right off but if you gradually accelerate it stumbles and wont accelerate past a certain point.
I'm not familiar with the Disty on a CJ5.� This was the best photo I could find of my current distributor. ( For some reason, I neglected to take close up photos of this side of my engine. )
Randy, You are correct. You have the original distributor set up.� RH and I do not.� Ours are likely replacement distributors for later Willys.� The mounting hole in your mounting bracket is a mounting and adjusting slot for me.
Here is a post at the 2A page while I was fighting this battle.� It may be helpful to you and Ranchhopper.� Pay particular attention to the responses from Sean.� He is the guru on L-134 engine timing.
This discussion got me thinking as my engine will go together soon...so looking in the service manual reprint that I have paragraph D-85 explains the install of the oil pump and the orientation of the distributor drive.
But my distributor does not have the adjustment limiting slot, just a pinch bolt, so theoretically I could rotate it 360 degrees...or so it seems...
Do I have the right adjuster? The Distributor is an IAD 4008.
It's been a while, but if memory serves, I turned it counter clock wise...peering down the distributor hole
or
Clock wise if you are looking up through the oil pump hole.
This is a helical gear on the oil pump. The trick is to move it one tooth, (which I think represents about a 30 degree change) but the helical style gear will move when you re-insert it and it make contact with the gear on the camshaft. Same thing when you pull it out.
I had a tendency to think I moved it one tooth, but it kept on ending up in the same place. !%@$ helical gears!!!
Thanks Tim which way did you turn it I dont want to have to disassemble it again if I turn it the wrong way my distributor is turned all the way to the right the jam bolt is at the top of the adjustment slot on the back of the distributor.
RH, � You are describing the exact same issue I was having. � You have to pull the oil pump and move its gear a tooth.
Which I must add, is a real pain in the rump on a fully assembled Willys.� I ended up pulling the exhaust pipe off the manifold.� This gave me a little more room, but it was still tight.�
I will add that once I was able to time the engine correctly, it ran like a fresh rebuild.
I have gone over the whole thing on the jeep now what I have noticed is the distributor has been turned all the way to the end of its adjustment. I have a friend who thinks it is one tooth off a vacuum gauge tells me its timing is running retarded but there is no more adjustment to advance it. How does one go about setting the distributor one more tooth forward since there is no drive gear on the distributor shaft?
If it is idling well, then you have no vacuum leak. I'm in the camp with the distributor problem. Gummed-up flyweights or worn posts they turn on, or springs that have lost their tension.