The CJ3A Page CJ3B.info

Post reply

Warning: this topic has not been posted in for at least 120 days.
Unless you're sure you want to reply, please consider starting a new topic.

Note: this post will not display until it's been approved by a moderator.

Name:
Email:
Subject:
Message icon:
Verification:
Type the letters shown in the picture
Listen to the letters / Request another image

Type the letters shown in the picture:
Write the word between words Jeep from this JeepWILLYSJeep?:
How many slot has a GPW grill?  7 - 9 - 11:

shortcuts: hit alt+s to submit/post or alt+p to preview


Topic Summary

Posted by: 1955CJ-5
« on: June 18, 2013, 07:15:15 PM »

You betcha!
Posted by: garage gnome
« on: June 18, 2013, 07:05:16 PM »

Thanks!
Posted by: 1955CJ-5
« on: June 18, 2013, 06:48:50 PM »

OK...here is a picture of the old originals..

They are Torrington Bearings, # B-188

You might be able to source a more accurate measurement.



Posted by: garage gnome
« on: June 18, 2013, 06:26:02 PM »

I'm going to make a bushing. Those needle bearings are not the greatest thing in the world.
Posted by: 1955CJ-5
« on: June 18, 2013, 03:07:13 PM »

Mine is already back together and installed. But I have the old bearings..I never throw anything out....I'll see if I can find them, they have a number that you may be able to cross reference, or at the very least I can measure them...
Posted by: garage gnome
« on: June 18, 2013, 08:09:28 AM »

I need to know the diameter of the hole in the bell crank that the bearing goes in. Thanks!