The CJ3A Page CJ3B.info

Post reply

Warning: this topic has not been posted in for at least 120 days.
Unless you're sure you want to reply, please consider starting a new topic.

Note: this post will not display until it's been approved by a moderator.

Name:
Email:
Subject:
Message icon:
Verification:
Type the letters shown in the picture
Listen to the letters / Request another image

Type the letters shown in the picture:
Write the word between words Jeep from this JeepWILLYSJeep?:
How many slot has a GPW grill?  7 - 9 - 11:

shortcuts: hit alt+s to submit/post or alt+p to preview


Topic Summary

Posted by: AZJeepNut
« on: June 16, 2013, 08:52:53 AM »

That's a great solution . . . simple, inexpensive, and it works. Thanks!
Posted by: F Bill
« on: June 15, 2013, 08:56:06 PM »

A Harbor Freight wooden furniture dolly with a chunk of 3/4 plywood on top works well. Jeep engines stand up well on their own, but it wouldn't hurt to run a ratchet strap around it to keep it from falling over. I have several of the dollies around the shop and even the smallest ones they sell work for jeep motors. Don't get the plastic ones, and check the grain direction on the wooden ones.
Posted by: AZJeepNut
« on: June 15, 2013, 04:56:28 PM »

The garage is too small for all the large and heavies that are accumulating as my CJ disassembly nears completion. Soooo, I'm thinking an engine cradle on wheels might be a useful addition. Anyone built one for the Go Devil? If you have, would you be willing to share the measurements?