The CJ3A Page CJ3B.info

Post reply

Warning: this topic has not been posted in for at least 120 days.
Unless you're sure you want to reply, please consider starting a new topic.

Note: this post will not display until it's been approved by a moderator.

Name:
Email:
Subject:
Message icon:
Verification:
Type the letters shown in the picture
Listen to the letters / Request another image

Type the letters shown in the picture:
Write the word between words Jeep from this JeepWILLYSJeep?:
How many slot has a GPW grill?  7 - 9 - 11:

shortcuts: hit alt+s to submit/post or alt+p to preview


Topic Summary

Posted by: 1955CJ-5
« on: June 07, 2013, 09:50:42 AM »

Thanks Tim,

I'll be able to get it really close..won't do it today as the hole saw I bought is a 7/8"...The trick is turning the lip inboard...I may not try...I tried it earlier on a practice piece and it was a little rough.......
Posted by: athawk11
« on: June 06, 2013, 11:48:57 PM »

Randy,�
I measured 3" x 3/4".� I confirmed this on two different Willys.� I measured 1 1/2" back from the step.�


I couldn't find a very good close up.� Sorry...

If nobody else posts a close up, I'll take a picture and post it tomorrow.


Posted by: 1955CJ-5
« on: June 06, 2013, 06:29:53 PM »

Does someone happen to know the dimensions of the side floor drains that are on both sides of the 3a aft of the side step?

I think it's in the 7/8" by 3" range but I'm not sure.

Also if someone knows or can measure how far aft the hole's front lip is from the step..

A picture would be really cool....

Thanks

Randy