The CJ3A Page CJ3B.info

Post reply

Warning: this topic has not been posted in for at least 120 days.
Unless you're sure you want to reply, please consider starting a new topic.

Note: this post will not display until it's been approved by a moderator.

Name:
Email:
Subject:
Message icon:
Verification:
Type the letters shown in the picture
Listen to the letters / Request another image

Type the letters shown in the picture:
Write the word between words Jeep from this JeepWILLYSJeep?:
How many slot has a GPW grill?  7 - 9 - 11:

shortcuts: hit alt+s to submit/post or alt+p to preview


Topic Summary

Posted by: 1955CJ-5
« on: May 28, 2013, 11:02:19 PM »

I know it is wrong but I've used pry bars and large screw drivers....

If they won't budge without bending you can gently knock them fore and aft and up and down with a dead blow hammer/mallet and sometimes they will loosen. Heat would help...

Posted by: PaulS
« on: May 28, 2013, 10:54:16 PM »

Any tips for pulling hub caps without the special puller they show in the service manual?

Thanks,

Paul