The CJ3A Page CJ3B.info

Post reply

Warning: this topic has not been posted in for at least 120 days.
Unless you're sure you want to reply, please consider starting a new topic.

Note: this post will not display until it's been approved by a moderator.

Name:
Email:
Subject:
Message icon:

Verification:
Type the letters shown in the picture
Listen to the letters / Request another image

Type the letters shown in the picture:
Write the word between words Jeep from this JeepWILLYSJeep?:
How many slot has a GPW grill?  7 - 9 - 11:

shortcuts: hit alt+s to submit/post or alt+p to preview


Topic Summary

Posted by: ranchhopper
« on: April 28, 2013, 10:19:53 PM »

I will try it but its full of dirt it doesnt look like it could let anything through.
Posted by: garage gnome
« on: April 28, 2013, 07:10:39 PM »

The primer cup appears to be open. Have you tried closing it? You said it sounded like a vacuum leak and that could cause it!  ;)
Posted by: ranchhopper
« on: April 28, 2013, 06:56:45 PM »

I will have someone rebuild it for me thanks for the help I have no idea why thats on there it was there when I bought it.
Posted by: garage gnome
« on: April 28, 2013, 06:40:12 PM »

Sounds like the high speed jet is plugged up on it. You'll have to get a carb kit and rebuild it or send it out someplace if you don't feel comfortable doing it yourself. A member here, scoutpilot, rebuilds WOs. I don't know if he does YFs. These carbs are very easy to rebuild (I think).

BTW, why is the there a hit and miss engine primer cup on your intake? (the brass thing on the right)
Posted by: ranchhopper
« on: April 28, 2013, 06:27:38 PM »

I got my 3A running this week it has a carter YF carburetor the jeep starts good I dont even need to choke it but anything past 1/3 throttle it starts to stumble. The jeep runs like when the vacuum line comes off a newer vacuum advance distributor the way it stumbles and wont accelerate past that point. I have never had an older jeep so Im at a stand still until I can figure out what the problem is I know it has the wrong intake manifold on it from a later model jeep one other strange thing when it runs there is a lot of condensation on the riser under the carb it just drips water off of it after running a few minutes any help or suggestions would be appreciated.