The CJ3A Page CJ3B.info

Post reply

Warning: this topic has not been posted in for at least 120 days.
Unless you're sure you want to reply, please consider starting a new topic.

Note: this post will not display until it's been approved by a moderator.

Name:
Email:
Subject:
Message icon:

Verification:
Type the letters shown in the picture
Listen to the letters / Request another image

Type the letters shown in the picture:
Write the word between words Jeep from this JeepWILLYSJeep?:
How many slot has a GPW grill?  7 - 9 - 11:

shortcuts: hit alt+s to submit/post or alt+p to preview


Topic Summary

Posted by: macrisel
« on: April 15, 2013, 01:00:48 PM »

Thanks guys.  I made it back out the the shop this weekend and had a chance to play with the switch.  Turns out, I did just have to back the rod out of the master cylinder quite a bit.  I had put the new master cylinder on when I only had the chassis finished three years ago.  By the time I added the aftermarket tub (with the firewall angle slightly different), and the draft pads both my clutch and brakes were too tight and had to be backed off.

Imagine my suprise when I tried to pull my jeep out of the shop after a year and it wouldn't move!  The engine started just fine but when you let out on the clutch nothing moved.  After a brief fit (maybe not so brief) I crawled under the jeep and saw the clutch wasn't releasing all the way.. ::)  I readjusted the clutch and all is right with the world.
Posted by: calvinhunt
« on: April 10, 2013, 01:56:11 AM »

My brake light switch takes a fair amount of brake fluid pressure to activate it.  If a bump in the road does it I would suspect a short.  
Posted by: garage gnome
« on: April 09, 2013, 05:03:59 PM »

You could have an air bubble in the switch.
Posted by: macrisel
« on: April 09, 2013, 03:15:37 PM »

So I have my wiring harness in and everything appears to be working.  I did notice one thing though when I was driving around my yard.  My brake light switch is extremely sensitive and will activate the brake lights with just the SLIGHTEST bounce.

Do I need to back my plunger out on the master cylinder a little bit?