The CJ3A Page CJ3B.info

Post reply

Warning: this topic has not been posted in for at least 120 days.
Unless you're sure you want to reply, please consider starting a new topic.

Note: this post will not display until it's been approved by a moderator.

Name:
Email:
Subject:
Message icon:

Verification:
Type the letters shown in the picture
Listen to the letters / Request another image

Type the letters shown in the picture:
Write the word between words Jeep from this JeepWILLYSJeep?:
How many slot has a GPW grill?  7 - 9 - 11:

shortcuts: hit alt+s to submit/post or alt+p to preview


Topic Summary

Posted by: garage gnome
« on: March 28, 2013, 07:49:42 PM »

Yes, the bottom is supposed to be a "press" type fit. The clamp just stabilizes the tube so it doesn't wobble around like mine does.
Posted by: Jesse
« on: March 28, 2013, 07:43:49 PM »

Hmm I'm pretty sure we never had that bracket, and inspection of a Packard flathead oiltube showed that the tube was pressed in place.

I took a nail and lightly dimpled the bottom edge maybe 3 times and knocked it in with a wood block. Maybe threw sealer on there as well.

-Jesse
Posted by: maximushuntermus
« on: March 26, 2013, 05:01:05 PM »

Alright thanks again, my friends...
Posted by: macrisel
« on: March 26, 2013, 01:02:28 PM »

I had this same issue on mine a little while ago and asked the same questions.  I ended up finding the correct size clamp at a hardware store.  A conduit clamp works very well.
Posted by: garage gnome
« on: March 26, 2013, 10:17:34 AM »

Here's mine.

Posted by: maximushuntermus
« on: March 26, 2013, 09:56:11 AM »

I cut it down to 423 kbytes and it looked good but came thru all blurred out not sure whats up...
Posted by: maximushuntermus
« on: March 26, 2013, 09:54:13 AM »

Ooops guess I still need to work on posting photos !!!!
Posted by: maximushuntermus
« on: March 26, 2013, 09:53:16 AM »

Photo
Posted by: garage gnome
« on: March 26, 2013, 09:37:09 AM »

Mine holds the dipstick tube perfectly vertical. Can you post a picture of the clamp? I'll go take one of mine and post it up.
Posted by: maximushuntermus
« on: March 26, 2013, 09:35:22 AM »

I suspected it had to be one of those however it seems like when I pry it over there, it makes the tube out of plumb, so it seems maybe the wrong clamp or something, it just doesn't reach, guess I will have to fabricate one couldn't find them online, least not yet. The bolt hole is maybe a 1/2" off the tube seems like it should be closer to an inch.
Posted by: garage gnome
« on: March 26, 2013, 07:09:04 AM »

It bolts to the lower left bolt hole of the oil filter bracket.
Posted by: maximushuntermus
« on: March 25, 2013, 11:49:08 PM »

verbage got tangled up like I was drinking or something. My dipstick clamp doesn't appear to line up with any bolt holes and would appreciate a photo of where it goes.
Posted by: maximushuntermus
« on: March 25, 2013, 11:46:58 PM »

Where does this bolt to my clamp does not line up with anything could be wrong clamp think it came off a Hurricane motor any photos appreciated. Any tips anywhere on how to post my photos?