The CJ3A Page CJ3B.info

Post reply

Warning: this topic has not been posted in for at least 120 days.
Unless you're sure you want to reply, please consider starting a new topic.

Note: this post will not display until it's been approved by a moderator.

Name:
Email:
Subject:
Message icon:
Verification:
Type the letters shown in the picture
Listen to the letters / Request another image

Type the letters shown in the picture:
Write the word between words Jeep from this JeepWILLYSJeep?:
How many slot has a GPW grill?  7 - 9 - 11:

shortcuts: hit alt+s to submit/post or alt+p to preview


Topic Summary

Posted by: gmcjr
« on: March 23, 2013, 08:21:17 PM »

A friend asked me awhile back if I wanted to work on his old MG, it had electrical problems and carb problems. I ran away fast as I could �[smiley=shocked.gif]
Posted by: ZekeD
« on: March 23, 2013, 01:45:16 PM »

LUCAS   Prince of Darkness
Posted by: gmcjr
« on: March 23, 2013, 11:25:19 AM »

;D ;D ;D ;D

Posted by: Macgraham
« on: March 23, 2013, 11:09:48 AM »

I was taught that power tools, generators, starters and Landrovers have smoke installed at the factory when they are built. It is our job to try and keep the smoke in, However if you let the smoke out it is never good. I let the smoke out of an old drill the other day, RIP.  ;) ;) ;D
Posted by: gmcjr
« on: March 23, 2013, 10:24:03 AM »

Also, check the surface the seal rides on for excess roughness, so it doesn't chew up the new seal.

Just remember, with a willys, its not a leak, its marking its territory in case a JK or a TJ comes by............ ;D ;D ;D


Quote

And if the wires leak smoke a lot, it is British.

Thanks FBill, I about lost my coffee on that one �[smiley=laugh.gif] [smiley=laugh.gif] [smiley=laugh.gif] [smiley=laugh.gif]

Makes you want to go out and buy a Land Rover, don't it?



Posted by: F Bill
« on: March 23, 2013, 09:43:36 AM »


Quote
Well, if it leaks it must be a Jeep. ;D


Or a Harley.... ;D

And if the wires leak smoke a lot, it is British.
Posted by: Carls_jeep
« on: March 23, 2013, 09:38:48 AM »

Well, if it leaks it must be a Jeep. ;D
Posted by: p3ferris
« on: March 23, 2013, 06:26:19 AM »

X2  Check out their helpful vidieos  too
Posted by: garage gnome
« on: March 22, 2013, 06:05:57 PM »

I get my parts from Walcks. They are real sticklers for quality parts. I would do the differentials first and work my way up the drive train.
Posted by: ZekeD
« on: March 22, 2013, 03:19:57 PM »

I have decided to take my 49 CJ3 down to the frame.  But looking ahead, I see that
EVERYTHING leaks: Mains, Pumpkins, transfer.  Where do you start? And where are
The best places to get gaskets, bearings etc.......I am trying to get away without
Totally rebuilding the L head, it seems to run nicely after sitting for 15 years.

Thanks for your experience and opinion.

Zeke D.