The CJ3A Page CJ3B.info

Post reply

Warning: this topic has not been posted in for at least 120 days.
Unless you're sure you want to reply, please consider starting a new topic.

Note: this post will not display until it's been approved by a moderator.

Name:
Email:
Subject:
Message icon:
Verification:
Type the letters shown in the picture
Listen to the letters / Request another image

Type the letters shown in the picture:
Write the word between words Jeep from this JeepWILLYSJeep?:
How many slot has a GPW grill?  7 - 9 - 11:

shortcuts: hit alt+s to submit/post or alt+p to preview


Topic Summary

Posted by: Kenny_Kustom
« on: March 21, 2013, 10:26:41 PM »

Im thinking maybe a trim ring from the tcase shifters and a flat piece of rubber?
Posted by: Kenny_Kustom
« on: March 21, 2013, 09:52:52 PM »

This is what I'm dealing with.
Posted by: macrisel
« on: March 21, 2013, 04:40:02 PM »

My thread below has the block I just built for my foot starter using Bob W's measurments in his book.

http://cj3apage.com/forum-yabb/YaBB.pl?num=1357924352/15#15

I made my block out of composite decking board to avoid rot. �After a coat of paint, you can barely tell its not real wood.
Posted by: F Bill
« on: March 20, 2013, 08:43:31 PM »

There is a wooden block that screws to the floor. Check Bob W's site for the dimensions....

http://www.cj3a.info/tech/sblock.html

We have some info on our home page links but it is mostly incorrect, especially about where the spring goes..That will get corrected in time.
Posted by: Kenny_Kustom
« on: March 20, 2013, 08:32:24 PM »

Is there supposed to be anything around or over the opening in the floor that the foot starter rod comes through?
My hole is a little bigger than it should be i think..