The CJ3A Page CJ3B.info

Post reply

Warning: this topic has not been posted in for at least 120 days.
Unless you're sure you want to reply, please consider starting a new topic.

Note: this post will not display until it's been approved by a moderator.

Name:
Email:
Subject:
Message icon:
Verification:
Type the letters shown in the picture
Listen to the letters / Request another image

Type the letters shown in the picture:
Write the word between words Jeep from this JeepWILLYSJeep?:
How many slot has a GPW grill?  7 - 9 - 11:

shortcuts: hit alt+s to submit/post or alt+p to preview


Topic Summary

Posted by: ZekeD
« on: March 20, 2013, 11:55:33 PM »

Will do... its -2C right now inside the shed,    I'll wait for some warm.

Regards
Zeke
Posted by: athawk11
« on: March 20, 2013, 01:38:27 PM »

Z,

The placement is about right.  It doesn't extend under the hand brake drum.

I had to do what Mac describes also. The skid plates do take some abuse. �Better it than the tranny and TC.

Your skid plate attaches to a bolt on cross member. �It could also be pretty bent up. �I guess the transmission mount could be gone too.

Shoot a picture a little further back. �It might help us see what's happening.

Tim
Posted by: Macgraham
« on: March 20, 2013, 01:22:10 PM »

Looks like it is bent up to me. Mine was the same and I took a bar and bent it down to just below the ebrake backing plate.
Posted by: ZekeD
« on: March 20, 2013, 11:59:24 AM »

My 49 C3 has this oddity....(besides the owner) Isnt the skid plate supposed to come further back and lower?

Any advice on how far back and how low?