The CJ3A Page CJ3B.info

Post reply

Warning: this topic has not been posted in for at least 120 days.
Unless you're sure you want to reply, please consider starting a new topic.

Note: this post will not display until it's been approved by a moderator.

Name:
Email:
Subject:
Message icon:
Verification:
Type the letters shown in the picture
Listen to the letters / Request another image

Type the letters shown in the picture:
Write the word between words Jeep from this JeepWILLYSJeep?:
How many slot has a GPW grill?  7 - 9 - 11:

shortcuts: hit alt+s to submit/post or alt+p to preview


Topic Summary

Posted by: jamesr
« on: January 28, 2013, 02:07:43 PM »

yes
Posted by: Judge
« on: January 27, 2013, 06:28:48 PM »

I have �a Hesse Hornet air compressor . These are basically a L134 Jeep engine running on 2 cy's and pumping air on the other 2. � I want to check timing and note there is a "pointer" on the block right over the front pully with a T �and 5. �OK, TDC and 5 degrees before TDC, I assume. �Now I need a mark on the pulley --BTW it is a double pulley, although only on is used for the governor --no alt or gen. �There is a small V notch on the inside pully. �Is this the mark I �need to time it? �thanks �