The CJ3A Page CJ3B.info

Post reply

Warning: this topic has not been posted in for at least 120 days.
Unless you're sure you want to reply, please consider starting a new topic.

Note: this post will not display until it's been approved by a moderator.

Name:
Email:
Subject:
Message icon:

Verification:
Type the letters shown in the picture
Listen to the letters / Request another image

Type the letters shown in the picture:
Write the word between words Jeep from this JeepWILLYSJeep?:
How many slot has a GPW grill?  7 - 9 - 11:

shortcuts: hit alt+s to submit/post or alt+p to preview


Topic Summary

Posted by: Bedrock
« on: October 16, 2012, 04:44:20 PM »

Thank you for the information.
Posted by: Carls_jeep
« on: October 15, 2012, 10:00:26 PM »

Get a VOM and measure the resistance of the coil in the horn. Put an amp meter in line with the horn and blow it to get a reading. Volts times amps = watts so X=amps so 6v times X = watts and that is the wattage of the resistor you will need for the horn. A resistor equal to the resistance of the coil and the wattage it draws is the value of the resistor you will need.
Posted by: Bedrock
« on: October 15, 2012, 07:14:09 PM »

I have a 6V CJ3A horn that I would like to use in my '51 3A, but my Willys has been converted to 12V.  Can anyone tell me what would be the proper value of drop down resistor to use to get the voltage down, and where I might get one of these?  I know that some people use a 6V horn with a 12V system with no resistor and are careful how they use the horn.  I would prefer to install a resistor if I can get one.   Thanks in advance.

George