The CJ3A Page CJ3B.info

Post reply

Warning: this topic has not been posted in for at least 120 days.
Unless you're sure you want to reply, please consider starting a new topic.

Note: this post will not display until it's been approved by a moderator.

Name:
Email:
Subject:
Message icon:

Verification:
Type the letters shown in the picture
Listen to the letters / Request another image

Type the letters shown in the picture:
Write the word between words Jeep from this JeepWILLYSJeep?:
How many slot has a GPW grill?  7 - 9 - 11:

shortcuts: hit alt+s to submit/post or alt+p to preview


Topic Summary

Posted by: Macgraham
« on: October 01, 2012, 11:52:02 AM »

Thanks, Tim I will check it out. :)
Posted by: athawk11
« on: October 01, 2012, 11:31:21 AM »

Mac,

I'm just throwing out a thought.  I have a Solex.  It was running a bit rough, but I can't remember if it was at idle or throttle.  I developed a small leak below the float bowl.  I'm not sure where it was coming from.  It was hard to detect, as the fuel would evaporate the minute it hit the manifold.  I tightened all the nuts and screws.  The leak went away, and the Jeep ran as it should.

Tim
Posted by: Macgraham
« on: September 30, 2012, 10:41:52 PM »

My solex carb worked just fine for the first 4 days on the Utah trip but on my last day it started to act up. Would not idle, seemed to flood when shut off, but was fine when the revs were up. I have no spacer behind the fuel pump. Can't figure why it would just change from being good to not! Any ideas out there? Even with the small carb problem it was the best Jeep trip I have been on thanks to Calvin and Lucille, the amazing hosts, and Carl and Betty who were always ready to test the Jeep to its limit. Don't miss it if any of you get a chance to go to this area. :)