The CJ3A Page CJ3B.info

Post reply

Warning: this topic has not been posted in for at least 120 days.
Unless you're sure you want to reply, please consider starting a new topic.

Note: this post will not display until it's been approved by a moderator.

Name:
Email:
Subject:
Message icon:

Verification:
Type the letters shown in the picture
Listen to the letters / Request another image

Type the letters shown in the picture:
Write the word between words Jeep from this JeepWILLYSJeep?:
How many slot has a GPW grill?  7 - 9 - 11:

shortcuts: hit alt+s to submit/post or alt+p to preview


Topic Summary

Posted by: Bob W
« on: August 09, 2012, 05:58:50 AM »

Left thread lug nuts may also have a line indented in them as an identifier.
Posted by: dodjh
« on: August 08, 2012, 10:55:18 PM »

Carl....there are so many shades of paint on them, I will have to wire brush them down to see.

I measured the drums and they are 11".
Posted by: Carls_jeep
« on: August 08, 2012, 10:11:35 PM »

The drivers side lugs are left hand and the passenger side is right hand. On the end of the lug the Lugs may have a L or a R if they are original type.
Posted by: dodjh
« on: August 08, 2012, 09:23:01 PM »

Well my front driver side lug nuts are left handed.....didn't notice any stamp but will look when removing the other

three (3) tires.
Posted by: bretto
« on: August 08, 2012, 08:59:28 PM »

If there is a 'R' stamped on the end of the lug its a right handed thread (counter-clockwise to loosen), 'L' stamp for left handed thread (clockwise to loosen).  If there is nothing at all stamped, its a good chance the are right handed threaded stud that were changed at one time since that is what is standard now.
Posted by: dodjh
« on: August 08, 2012, 08:10:43 PM »

Hi....I read a forum post about front end right side RT (reverse thread) lug nuts and other side different lug nut

removal.

Was that about the tires or the spring hangers?

I was just trying to remove driver side front tire and my impact driver couldn't budge the nuts...so I went

to a breaker bar and broke the yoke swivel on the breaker bar.

Then I remembered the different pattern for something.....

Is the lug removal different for each tire?