The CJ3A Page CJ3B.info

Post reply

Warning: this topic has not been posted in for at least 120 days.
Unless you're sure you want to reply, please consider starting a new topic.

Note: this post will not display until it's been approved by a moderator.

Name:
Email:
Subject:
Message icon:
Verification:
Type the letters shown in the picture
Listen to the letters / Request another image

Type the letters shown in the picture:
Write the word between words Jeep from this JeepWILLYSJeep?:
How many slot has a GPW grill?  7 - 9 - 11:

shortcuts: hit alt+s to submit/post or alt+p to preview


Topic Summary

Posted by: Carls_jeep
« on: June 12, 2012, 09:23:06 PM »

I finally had a chance to look in a bearing catalog for cam bushing dimensions. Other than the bushing for the #1 journal the only other journal that has a size listed in the catalog is the #4 journal. That leaves #2 & 3 with no matching dimentions of a manufactured cam bushing.
Posted by: Carls_jeep
« on: May 10, 2012, 08:45:25 AM »

There has been some discussion about putting cam bushings in the bores that don't have them. I checked the cam journal sizes of the 289-302 Ford cam and none of them match the Jeep cam size. That makes all comments about using Ford cam bushings not valid.

So, has anyone actually had the block bored and bushings installed in #2,#3 and #4. cam bores or is it just an urban legend?