The CJ3A Page CJ3B.info

Post reply

Warning: this topic has not been posted in for at least 120 days.
Unless you're sure you want to reply, please consider starting a new topic.

Note: this post will not display until it's been approved by a moderator.

Name:
Email:
Subject:
Message icon:

Verification:
Type the letters shown in the picture
Listen to the letters / Request another image

Type the letters shown in the picture:
Write the word between words Jeep from this JeepWILLYSJeep?:
How many slot has a GPW grill?  7 - 9 - 11:

shortcuts: hit alt+s to submit/post or alt+p to preview


Topic Summary

Posted by: Carls_jeep
« on: June 10, 2012, 10:02:32 AM »

You should be able to use a hammer and punch and work your way around the ring gear to drive it off. If you have a oxy acy torch you can lay the new ring gear on four fire bricks and heat it to a dull red and with tongs drop it on the flywheel. Be sure to completely clean the area where the ring gear will go on the flywheel.

If you've never done something like that before it will be an experience you can tell others about. �;D
Posted by: Shalka04
« on: June 10, 2012, 03:40:54 AM »

I'm in a spot where I have a 129 tooth gear on my fly wheel and actually need the 124 tooth set up.  I've been hearing alot of just heat the old one up slip it off and heat the new one up...... is it that easy?

I'm not looking for another steering wheel experience, that SOB took three days to get off.

Thanks,
-John