Posted by: Carls_jeep
« on: May 18, 2012, 10:52:09 PM »If your sure it is tranny oil rather than engine oil then the input shaft seal is worn out. The seal is a felt ring with a rubber washer on one side. You have to soak the felt seal in oil for an hour or so before installing it.
You have to pull the trann/transfer cases and pull the throw out bearing and front bearing retainer. The seal goes on the input shaft and I think the rubber goes toward the bearing but you need to look that up.
You have to pull the trann/transfer cases and pull the throw out bearing and front bearing retainer. The seal goes on the input shaft and I think the rubber goes toward the bearing but you need to look that up.