The CJ3A Page CJ3B.info

Post reply

Warning: this topic has not been posted in for at least 120 days.
Unless you're sure you want to reply, please consider starting a new topic.

Note: this post will not display until it's been approved by a moderator.

Name:
Email:
Subject:
Message icon:
Verification:
Type the letters shown in the picture
Listen to the letters / Request another image

Type the letters shown in the picture:
Write the word between words Jeep from this JeepWILLYSJeep?:
How many slot has a GPW grill?  7 - 9 - 11:

shortcuts: hit alt+s to submit/post or alt+p to preview


Topic Summary

Posted by: jamesr
« on: April 21, 2012, 06:12:32 PM »

I agree with harvey wallbanger.  No sense half assing it now.
Posted by: Harveynailbanger
« on: April 13, 2012, 10:11:52 PM »

I would pull it apart. you are already there, xfer is out and accessible, no reason not too.
Posted by: BMIC
« on: April 13, 2012, 07:28:29 AM »

The last task after replacing parts, gaskets, cleaning, and painting my Transfer Case was to slide in new shift rod seals. Of course while seating it the rubber seal caught the shift rod cut and I mangled it. Short of taking the TC apart can I carefully drill a series of small holes in the seal to weaken it and then remove it with needle nose pliers or is drilling it too risky?     :exclamation]