The CJ3A Page CJ3B.info

Post reply

Warning: this topic has not been posted in for at least 120 days.
Unless you're sure you want to reply, please consider starting a new topic.

Note: this post will not display until it's been approved by a moderator.

Name:
Email:
Subject:
Message icon:

Verification:
Type the letters shown in the picture
Listen to the letters / Request another image

Type the letters shown in the picture:
Write the word between words Jeep from this JeepWILLYSJeep?:
How many slot has a GPW grill?  7 - 9 - 11:

shortcuts: hit alt+s to submit/post or alt+p to preview


Topic Summary

Posted by: turkehunt
« on: February 07, 2012, 04:22:34 PM »

Thanks Larry  :)              Just finished up installing rebuilt steering box after removing fender ,wheel as you suggested ! I was able to depress the brake pedal and get the column in  Worked GREAT  ;) Thanks so much for the help !!!    Jim
Posted by: Macgraham
« on: February 04, 2012, 08:58:00 AM »

Thanks from me too. I'm getting close to the same performance.
Posted by: turkehunt
« on: February 04, 2012, 05:15:14 AM »

Larry       Thanks for the great information ! This should speed things along.  8-)                               Jim
Posted by: rocketeer
« on: February 03, 2012, 09:34:30 PM »

Here's how I did it, others may have a different approach. This is from an old post I made on the CJ2A forum. If you already filled the box with oil you'll have to wrap something around the shaft after you remove the outer shaft tube. With this method you do not have to remove the exhaust nor the oil pump.

Remove the outer column
Remove the pitman arm
Jack up the LF and remove the wheel
Remove the LF fender
Disconnect the brake light wires and pull out of the way.
Remove the brake pedal (trust me), just the pedal.
Rotate the steering box so the pitman shaft points upward
Lay the assembly on it's side above the frame with the shaft pointing at the hole in the firewall
Insert the shaft through the hole in the firewall
You should be able to maneuver the box into position, being careful of jabbing the front seat with the shaft
Bolt the box to the frame but do not tighten yet

The rest you should be able to figure out.
Just remember to center up the steering before putting the pitman arm back on

Larry
Posted by: turkehunt
« on: February 03, 2012, 07:43:25 PM »

 ::)         Anybody got any tips on replacing my complete steering column with rebuilt steering box attached ???? I rebuilt a sreering column [ steering shaft , upper bearing replaced on shaft, rebuilt steering box & new pittman arm] rebuilt drag link . replacing tie rod ends. new bell crank and bell crank rebuild !!!!   Any tips on getting the new shaft up through the floorboard and what obstacles I likely will face  ?? exhaust clearance,brake lines etc.etc.    Thanks in advance for your replys  ! ;)