The CJ3A Page CJ3B.info

Post reply

Warning: this topic has not been posted in for at least 120 days.
Unless you're sure you want to reply, please consider starting a new topic.

Note: this post will not display until it's been approved by a moderator.

Name:
Email:
Subject:
Message icon:
Verification:
Type the letters shown in the picture
Listen to the letters / Request another image

Type the letters shown in the picture:
Write the word between words Jeep from this JeepWILLYSJeep?:
How many slot has a GPW grill?  7 - 9 - 11:

shortcuts: hit alt+s to submit/post or alt+p to preview


Topic Summary

Posted by: Macgraham
« on: February 03, 2012, 06:09:09 PM »

I am going through the same questions. I have an engine with the small diameter dist Autolite no.4177-1. says it will fit all l 134 engines. I switched to an Autolite no. IAD 4008 which is the larger diameter dist, with internal condensor. I think you need a cap for the 3 1/2 inch diameter 4008. Mac
Posted by: ventport
« on: February 03, 2012, 04:08:34 PM »

I bought a distributor cap at a swap meet a while back for my CJ3A.  It was in a different box but was labeled AL-134 in magic marker.  It does not fit my CJ as the diameter is too small.  Did Willys use two different size distributors in their production?  If so is the AL-134 the correct number for the small distributor, and what years did it fit so i can resell it.  What is the correct part number for the big diameter distributor so I can get the correct cap? Thanks Brian