Posted by: Carls_jeep
« on: December 14, 2011, 08:33:21 PM »You don't need to make a gage, just lower the pin to the bottom of the loop and snug the nut and your done. The only reason I can see for the factory gage is convenience or to sell a tool or to make you think it's critical.
Today I did some checking on my Jeep. Read below.
I got curious and checked my Jeep's metering rod setting. The Jeep carb is running just fine so it should be close but I don't remember how I went about setting it when I rebuilt it.
With the throttle screw backed off the metering rod has .007" free travel and the spring holds it down as it should do. Then I screwed the throttle screw back in to where it was and the travel is .030" with the spring still holding the rod down. The lift off of the rod from the jet occurs with very little throttle opening so it would be about 20 mph I suppose.
When I get a factory tool I will do a comparison of the factory tool to the home made tool in my Jeep carb and the used carbs. If the home made and factory tool setting allows about .005" of free travel then you could set the metering rod without a tool by just allowing a little movement in the rod.
It's not really rocket science setting these carbs and I suppose they would tolerate a little variation in the setting. In fact I don't remember things being this complicated setting the metering rods in Chevy carbs.
We'll see how it comes out.
Today I did some checking on my Jeep. Read below.
I got curious and checked my Jeep's metering rod setting. The Jeep carb is running just fine so it should be close but I don't remember how I went about setting it when I rebuilt it.
With the throttle screw backed off the metering rod has .007" free travel and the spring holds it down as it should do. Then I screwed the throttle screw back in to where it was and the travel is .030" with the spring still holding the rod down. The lift off of the rod from the jet occurs with very little throttle opening so it would be about 20 mph I suppose.
When I get a factory tool I will do a comparison of the factory tool to the home made tool in my Jeep carb and the used carbs. If the home made and factory tool setting allows about .005" of free travel then you could set the metering rod without a tool by just allowing a little movement in the rod.
It's not really rocket science setting these carbs and I suppose they would tolerate a little variation in the setting. In fact I don't remember things being this complicated setting the metering rods in Chevy carbs.
We'll see how it comes out.