The death wobble is primarily caused by the king pin bearings being loose. �They don't have to be bad, just out of adjustment. �When properly adjusted the steering knuckle assembly is rather stiff to swing back and forth. �The stiffness is measured with a spring scale and is adjusted by adding or removing shims on the top king pin. � If the king pins are properly adjusted, the rest of the steering linkage could be really loose and it would still not wobble. �But if the king pins are loose, a good tight steering linkage could control the wobble for a while. �I believe that this is why some people have success with replacing other steering parts or with a shimmy dampener. �I did the same thing for many years but the wobble always came back until I started browsing these websites and learned about the steering knuckles. �Once I rebuilt mine, the problem went away completely. �
If you are going to open up the steering knuckles you might as well do a complete rebuild. �It really isn't difficult if you have any mechanical experience. � There are numerous descriptions of the king pin rebuild process. � My favorite is on Novak's site. �
http://www.novak-adapt.com/knowledge/steering_knuckle_repair.htm