The CJ3A Page CJ3B.info

Post reply

Warning: this topic has not been posted in for at least 120 days.
Unless you're sure you want to reply, please consider starting a new topic.

Note: this post will not display until it's been approved by a moderator.

Name:
Email:
Subject:
Message icon:

Verification:
Type the letters shown in the picture
Listen to the letters / Request another image

Type the letters shown in the picture:
Write the word between words Jeep from this JeepWILLYSJeep?:
How many slot has a GPW grill?  7 - 9 - 11:

shortcuts: hit alt+s to submit/post or alt+p to preview


Topic Summary

Posted by: Matto
« on: November 27, 2011, 09:54:24 PM »

That looks like the grease seal on the inboard side of the inner wheel bearing. Just took one of mine apart to install locking hubs. Here's a link to the Vernco site showing installation of the front hubs.
http://www.vernco.com/FrontAxle/id461.htm
Matt
Posted by: Comanche_County
« on: November 27, 2011, 09:34:16 PM »

Gents,

The part in question is a National Seal #40566. �Can't remember where the darn thing goes and I'm currently typing with my dunce hat on.... I'm fairly certain it seals the hub shaft so wheel bearing grease doesn't get flung around in the brake drum. �I thought these went with my locking hubs because I usually keep parts sorted like rabid librarian on speed and these ended up in my container with my DualMatic Lockouts. �Classic case of not remembering how to put the lego castle back together. �I'm not going to get into how many times I pulled the front and rear drums today, it was embarrassing. �But they fit the rear hubs and seem to be a fit for the front hubs also.

I took a pic next to the lockouts for comparison....