Posted by: gsitts
« on: November 23, 2011, 10:31:16 PM »Hi, I'm in the middle of rewiring my new tub and am doing it wire by wire I've done this many times and I build electrical panels for a living so it not that hard for me. For those who might be so inclined here are a couple of tips. 1) make a copy of your dwg and mark each wire with a highliter as you put it in. 2) get a good crimping tool and use it properly. In my business I see a lot of wire not crimped correctly. Correctly means A) Stripped properly not nicked of cut up with a knife. B) Stripped the proper length to have the wire protruding slightly from the crimp. C) Insulation in the cup end but not in the crimp area. D) Not crimped until the wire is cut through. And finally After crimping pull on the wire to see how you did.
I hope this is helpful
Gordon
I hope this is helpful
Gordon