Posted by: Doug
« on: October 13, 2011, 10:20:58 PM »Have not been on here in months guys. � I offer my two cents. �The two cups you talk about might stop a tiny bit of leaking from the shifter, but not the tranny.
My tranny leaked from the input shaft like crazy. � Replaced the felt seal twice, even doubled up on them one time and it kept leaking like a sieve. � Then I looked inside my tranny. �I noticed in comparing to engineer drawings that there were two different engineered drawings. One willys drawings shows an oil slinger washer, similar to those in the differentials, at the input shaft. �The other willys drawings does not show it. �I took my tranny apart enough to install the oil slinger, returned the felt seals back to factory, put it together and my input shaft has not leaked a drop of oil in four years. � The oil slinger was keeping 99% of the oil �off the felt seal. �Then only 1% gets on the felt seal, just enough to keep it lubricated. �I think a lot of trannys are missing the oil slinger washer at the input shaft. �Try that. �
For leaks at the sealing joints between the transfer case and tranny, it is important to have them planed flat before mating. �Over the years they get warped from overtightening the bolts. � Hope that helps. �Doug.
My tranny leaked from the input shaft like crazy. � Replaced the felt seal twice, even doubled up on them one time and it kept leaking like a sieve. � Then I looked inside my tranny. �I noticed in comparing to engineer drawings that there were two different engineered drawings. One willys drawings shows an oil slinger washer, similar to those in the differentials, at the input shaft. �The other willys drawings does not show it. �I took my tranny apart enough to install the oil slinger, returned the felt seals back to factory, put it together and my input shaft has not leaked a drop of oil in four years. � The oil slinger was keeping 99% of the oil �off the felt seal. �Then only 1% gets on the felt seal, just enough to keep it lubricated. �I think a lot of trannys are missing the oil slinger washer at the input shaft. �Try that. �
For leaks at the sealing joints between the transfer case and tranny, it is important to have them planed flat before mating. �Over the years they get warped from overtightening the bolts. � Hope that helps. �Doug.
When I was younger I jumped in with both feet and hands. Now I look real good before I leap and sometimes I don't leap.