Posted by: Carls_jeep
« on: September 18, 2011, 10:26:01 AM »The brake switch is a pipe thread and screws into the banjo bolt the holds the brake line adapter onto the master cylinder. There is a copper washer on each side of the brake line adapter and if they are not leaking and the threads in the banjo bolt are and sealer will not stop it you may have to replace the banjo bolt.
There is a thread sealer made by Locktite that may do the trick. If you can't find that then use the mild bolt retainer locktite. Most people over tighten pipe threads. They figure keep turning until it stops and all that does is over stress the thread and maybe split the female threaded part.
Perhaps you or someone else has over tightened the brake switch and stressed the threads.
There is a thread sealer made by Locktite that may do the trick. If you can't find that then use the mild bolt retainer locktite. Most people over tighten pipe threads. They figure keep turning until it stops and all that does is over stress the thread and maybe split the female threaded part.
Perhaps you or someone else has over tightened the brake switch and stressed the threads.