Okay, �I am so excited. �I have a rolling chassis!! �I am working on the vacuum lines and exhaust.
I have a few questions on the exhaust. �I bought the complete kit from Walck's. �Pretty darn nice. �I don't seem to have any alignment issues, but I have a few questions. �I searched the old forum clear back to 2007 and this just doesn't seem to be an exciting topic, so I posted some photos to try and get some interest and feedback.
As my old exhaust system was a disaster, I have nothing to follow with regard to proper placement of the hangers except the two on the rear crossmembers. The obvious place to hang the rear pipe and muffler falls to the outside of the frame. �Is this right? �(See the last photo.)
Also, �the tail pipe that Walck's provided does not fit very tight. �It slides loosely into the muffler and when I say loosely, I mean loose. �Is this standard for the tail pipe, or is it possible I didn't get the correct one? �Walck's has been dead on with all my other orders, but I suppose they could have made a mistake. �If this is what it is, then I don't want to make a big stink with Walck's and I could just weld it. �I just don't think the clamp is going to tighten this gap.



