The CJ3A Page CJ3B.info

Post reply

Warning: this topic has not been posted in for at least 120 days.
Unless you're sure you want to reply, please consider starting a new topic.

Note: this post will not display until it's been approved by a moderator.

Name:
Email:
Subject:
Message icon:
Verification:
Type the letters shown in the picture
Listen to the letters / Request another image

Type the letters shown in the picture:
Write the word between words Jeep from this JeepWILLYSJeep?:
How many slot has a GPW grill?  7 - 9 - 11:

shortcuts: hit alt+s to submit/post or alt+p to preview


Topic Summary

Posted by: RandyA
« on: June 07, 2011, 09:48:44 PM »

Thanks...thats what i have done...
Posted by: p3ferris
« on: June 07, 2011, 05:41:20 PM »

I looked and there are no specs. in 2 of my books. So just tighten them up till it is pulled back and tight.  Use your judgement.
Posted by: RandyA
« on: June 05, 2011, 02:16:17 PM »

Hey all...is there a specific torque spec. for the nut on the yoke too drive line off the transfer case??assembled e brake with all new parts, except drum ...adjusted liners snug...then backed off seven turns...wanted too make sure before i re-install u joints and shaft..as always thanks in advance for your help....