The CJ3A Page CJ3B.info

Post reply

Warning: this topic has not been posted in for at least 120 days.
Unless you're sure you want to reply, please consider starting a new topic.

Note: this post will not display until it's been approved by a moderator.

Name:
Email:
Subject:
Message icon:
Verification:
Type the letters shown in the picture
Listen to the letters / Request another image

Type the letters shown in the picture:
Write the word between words Jeep from this JeepWILLYSJeep?:
How many slot has a GPW grill?  7 - 9 - 11:

shortcuts: hit alt+s to submit/post or alt+p to preview


Topic Summary

Posted by: jamesr
« on: March 27, 2011, 12:13:38 PM »

I had to replace one, and it was very inexpensive.  I think around $16.00, but not sure.  Check at Walks.  Jim
Posted by: Matto
« on: March 27, 2011, 09:25:33 AM »

At some point in time a previous owner installed JC Whitney springs and shackles on my 3A. I started to install original C shackles and discovered that the PO had cut the steel tube out of the shackle perch and welded in tubes with a smaller inside diameter. :( Can anyone tell me what the ID,OD, and length of the original tube is? I'm not sure if it's easier to repair the existing bracket or replace the whole part.
Matt