The CJ3A Page CJ3B.info

Post reply

Warning: this topic has not been posted in for at least 120 days.
Unless you're sure you want to reply, please consider starting a new topic.

Note: this post will not display until it's been approved by a moderator.

Name:
Email:
Subject:
Message icon:

Verification:
Type the letters shown in the picture
Listen to the letters / Request another image

Type the letters shown in the picture:
Write the word between words Jeep from this JeepWILLYSJeep?:
How many slot has a GPW grill?  7 - 9 - 11:

shortcuts: hit alt+s to submit/post or alt+p to preview


Topic Summary

Posted by: Carls_jeep
« on: March 22, 2011, 09:36:07 AM »

Yes, I welded my intake and exhaust manifolds with NiCad rod. You can braze them but you have to get the metal real clean and use flux so the brass sticks to the cast iron. Also, they may warp some from the heat so you will have to remachine the surface that bolts to the block.

If your not good at welding have an experienced welder do it. when you machine the surface of the ports you have to have both manifolds bolted together so they align correctly.
Posted by: BradleyDP
« on: March 21, 2011, 11:20:46 PM »

Has anyone had any success repairing a cracked intake manifold?
Can it be welded, epoxied, wrapped, etc...