The CJ3A Page CJ3B.info

Post reply

Warning: this topic has not been posted in for at least 120 days.
Unless you're sure you want to reply, please consider starting a new topic.

Note: this post will not display until it's been approved by a moderator.

Name:
Email:
Subject:
Message icon:

Verification:
Type the letters shown in the picture
Listen to the letters / Request another image

Type the letters shown in the picture:
Write the word between words Jeep from this JeepWILLYSJeep?:
How many slot has a GPW grill?  7 - 9 - 11:

shortcuts: hit alt+s to submit/post or alt+p to preview


Topic Summary

Posted by: jamesr
« on: February 03, 2011, 09:19:49 PM »

I used the vacuum line as a "chase" for the wiper wiring. �Be sure your windshield frame has a good ground to the tub. �The pivot point of the windshield, and the hold down clips are not the best conductor for a ground. �Also, if your wiper motors are mounted on rubber vibration dampners, be sure to run a ground from the motor housing too.  I actually formed a larger vacuum line so that I could pull a negative with the "+" voltage wire. �Most of "us" would see the difference in size, but most of "them" won't. My Willys is not "correct", but I have upgraded where it suits me, and my needs. Jim
Posted by: brotherdavid
« on: February 03, 2011, 05:48:32 PM »

I was wondering how to run wiring for my 6 volt electric wiper motors. I'm going to run one on each side. I would like to make it look as good as possible. I know this is not stock but I'd rather have the electric motors.