Posted by: F Bill
« on: January 31, 2011, 10:23:04 AM »When you sandblast rims, sand tends to get stuck between the rim halves...take some time before priming to use a sharp tool to scrape the seam between the inner and outer rim free of any foriegn particles. Blow it off well with an air gun too. Also this is where the rim will start to rust first, so you need to get a good solid coat of primer in there.. Brushing the primer in that area is the best way to soak the metal in protection..... We use a small acid brush or tiny paintbrush to make sure we get this area primed., using the thinned primer right out of the spray gun cup before we spray the rims. Don't worry about runs and drips, you will sand these out later.
If you have an old bar stool or something similar to use to hold your rime while spraying topcoat, and you can spin the rim while spraying, you will also get a better coverage. It is tough to cover ALL the rim without getting dry spots otherwise...
Good luck with the project...sure makes any jeep look nicer to have shiny clean rims!
If you have an old bar stool or something similar to use to hold your rime while spraying topcoat, and you can spin the rim while spraying, you will also get a better coverage. It is tough to cover ALL the rim without getting dry spots otherwise...
Good luck with the project...sure makes any jeep look nicer to have shiny clean rims!


The Willys rim sat there stoic. He called over someone else. They pulled off one part, put on another and after 5 minutes, they got the old tire off.