The CJ3A Page CJ3B.info

Post reply

Warning: this topic has not been posted in for at least 120 days.
Unless you're sure you want to reply, please consider starting a new topic.

Note: this post will not display until it's been approved by a moderator.

Name:
Email:
Subject:
Message icon:

Verification:
Type the letters shown in the picture
Listen to the letters / Request another image

Type the letters shown in the picture:
Write the word between words Jeep from this JeepWILLYSJeep?:
How many slot has a GPW grill?  7 - 9 - 11:

shortcuts: hit alt+s to submit/post or alt+p to preview


Topic Summary

Posted by: athawk11
« on: January 28, 2011, 11:44:17 AM »

Thanks Jim.

I'll try your suggestions.

Tim
Posted by: jamesr
« on: January 28, 2011, 09:01:29 AM »

yes, they had the cage.  Try a screw or fastner wholesaler.  Most of them will sell to you on a cash basis.  Jim
Posted by: athawk11
« on: January 27, 2011, 12:14:03 PM »

Thanks for your response Jim.

The nuts you picked up at Ace, did they have the CAGE and nut?  I did look at Depot, and they did have the nut, but didn't see them with the cage.

Tim
Posted by: jamesr
« on: January 26, 2011, 10:35:08 PM »

I replaced a couple on my tub also. �Got them at Ace, as well as Home Depot. �The �shift cover is 1/4" standard thread, except the top left closest to the foot feed is 5/16. fBe carful if you buy new bolts that they are not so long they hit the trans. or transfer cases. The seats are 5/16, standard. At least my '53 is. The firewall can be anything from 10-32 to 5/16 depending on what mounts to it. Jim
Posted by: athawk11
« on: January 26, 2011, 05:51:39 PM »

Hi everyone.

Looking for the right kind of nuts, the right sizes, and a decent supplier for replacement captive/cage nuts. �I replaced the floor pan and need one to mount the driver side seat. � A couple are missing from the transmission cover to floor mounts. (The hole is sort of square shaped on these.) �And finally, I am missing one on the firewall. �Not sure what was attached on this one, but the sheet metal is all torn around where it once was. �

So, Sizes? �Types? �Suppliers?

Project is a '49 CJ3A, (#36662). Motor replaced with a GPW (strange or no markings where markings should be) �Transmission and Transfer appear to be original. Date plate on transfer case: 5-10-48. �Willys ran great before I tore it apart. �Hopefully, it still will when I put it back together.

Thanks in advance for your thoughts and help.

 ï¿½