The CJ3A Page CJ3B.info

Post reply

Warning: this topic has not been posted in for at least 120 days.
Unless you're sure you want to reply, please consider starting a new topic.

Note: this post will not display until it's been approved by a moderator.

Name:
Email:
Subject:
Message icon:

Verification:
Type the letters shown in the picture
Listen to the letters / Request another image

Type the letters shown in the picture:
Write the word between words Jeep from this JeepWILLYSJeep?:
How many slot has a GPW grill?  7 - 9 - 11:

shortcuts: hit alt+s to submit/post or alt+p to preview


Topic Summary

Posted by: Carls_jeep
« on: January 02, 2011, 04:05:59 PM »

The grooves are to enhance the sealing. I rebuilt my master cylinder also and it was always my practice to put the grooved side of the washer toward an ungrooved surface. The grooved steel or cast iron surface will dig into a copper or brass washer and the grooves on the washer will help seal on a surface with no grooves.

I have seen it done both ways, flat to grooves or flat to flat, and it still sealed. Actually, copper washers will seal better than brass because they deform easier. I would suspect your washers are copper.
Posted by: mud pie
« on: January 02, 2011, 12:37:23 PM »

While rebuilding the master cylinder (is there anything on these Jeeps that you can't rebuild ?  :)) I noticed the brass washers are grooved on one side.  The brass "Y" fitting is also grooved on each side.  When rebuilding, do I place the washers with the grooved side to the grooved "Y" fitting ?  It would make sense, but ya never know, so I thought I would ask before I bolted that puppy back onto the frame.