Posted by: p3ferris
« on: January 01, 2011, 10:00:56 AM »
They are suppost to be that tight. What I did was I used a long screwdriver and reached behind the flywheel right where it was against the crank shaft. Placing it there I taped it then moved it to the side again I taped it. I did this repeatedly around the crank. Each time it would move the flywheel a very little, almost not to notice. After going around a few times it came off. The bolts press it back on when you tighten them up, so remember to tighten the bolts little by little, do not try to tighten a bolt all the way down on the first try rotate.