The CJ3A Page CJ3B.info

Post reply

Warning: this topic has not been posted in for at least 120 days.
Unless you're sure you want to reply, please consider starting a new topic.

Note: this post will not display until it's been approved by a moderator.

Name:
Email:
Subject:
Message icon:
Verification:
Type the letters shown in the picture
Listen to the letters / Request another image

Type the letters shown in the picture:
Write the word between words Jeep from this JeepWILLYSJeep?:
How many slot has a GPW grill?  7 - 9 - 11:

shortcuts: hit alt+s to submit/post or alt+p to preview


Topic Summary

Posted by: Weedhopper
« on: November 30, 2010, 02:08:23 PM »

Thanks for the photos, this helps alot. Is there a way to access the old postings?
Posted by: Bob W
« on: November 29, 2010, 07:45:32 PM »

Here are some links to wiring info...............

http://cj3apage.proboards.com/index.cgi?action=display&board=Tech&thread=824&page=1

http://cj3apage.proboards.com/index.cgi?action=display&board=Tech&thread=954&page=1

http://cj3apage.proboards.com/index.cgi?action=display&board=Tech&thread=1146&page=1
Posted by: Weedhopper
« on: November 29, 2010, 03:20:21 PM »

I'm to the point in my rebuid that I'm now re-wiring. My question is, Whats the correct routing of the harness from the rear to the main harness as it emerges at the engine bay?  inside or outside the body support bracket, through one of the holes in the bracket? It's been 2 years since I took the original wiring out and the pictures I took don't give me much to go on (neither does my memory).
If anyone has a photo that would be great.