The CJ3A Page CJ3B.info

Post reply

Warning: this topic has not been posted in for at least 120 days.
Unless you're sure you want to reply, please consider starting a new topic.

Note: this post will not display until it's been approved by a moderator.

Name:
Email:
Subject:
Message icon:
Verification:
Type the letters shown in the picture
Listen to the letters / Request another image

Type the letters shown in the picture:
Write the word between words Jeep from this JeepWILLYSJeep?:
How many slot has a GPW grill?  7 - 9 - 11:

shortcuts: hit alt+s to submit/post or alt+p to preview


Topic Summary

Posted by: rocketeer
« on: September 20, 2012, 08:36:47 PM »

Providing the rad will clear the sheetmetal of the grille, you would need to weld a pair of tangs underneath the front crossmember and add a support rod from the rad to the firewall. When I did mine I also changed the grille so I can't address whether or not a CJ3A grille will allow it to clear. The tangs, of course, must be aligned correctly as to spacing and angle. I acquired the tangs from a junker frame. There are notches in the tangs that have compound angles in order to fit under the crossmember which make it difficult to make one's own.







Larry
Posted by: Shalka04
« on: September 20, 2012, 03:57:21 PM »

Has any one had any experience slipping a bottom mount radiator into a side mount configuration.  

-John