Posted by: garage gnome
« on: March 12, 2013, 03:44:48 PM »Thanks Bill!
Yep, gmcjr did pretty much what I did except I used a computer guided plasma cutter. I guess great minds think alike! �8-) As stated, it should be a snug fit. I have to tap my spindles on with a hammer. I don't know if gmcjr did this, but before I welded mine together, I put a big chamfer on mine and welded it with the welder set for 1/2" or 3/8" thick steel.
Bill, I think you are over thinking it. Take your machinist hat off and put your welder cap on. �;)
These are the two plates you need, each are a 1/4" thick. One with a center hole and the other without it. The outside diameter is the same as the spindle's flange, and the inside diameter of the hole is the same has the diameter of the boss on the back side of the spindle. Put a few bolts in and weld them together. Then put it on the axle tube with some magnets, center it up and blast it on. Not much harder than that. �;)
You could make a third one similar to the one on right, but with a hole the same size as the diameter of the pipe if you really wanted it strong. The left plate would then be sandwiched between the two with holes.

Yep, gmcjr did pretty much what I did except I used a computer guided plasma cutter. I guess great minds think alike! �8-) As stated, it should be a snug fit. I have to tap my spindles on with a hammer. I don't know if gmcjr did this, but before I welded mine together, I put a big chamfer on mine and welded it with the welder set for 1/2" or 3/8" thick steel.
Bill, I think you are over thinking it. Take your machinist hat off and put your welder cap on. �;)
These are the two plates you need, each are a 1/4" thick. One with a center hole and the other without it. The outside diameter is the same as the spindle's flange, and the inside diameter of the hole is the same has the diameter of the boss on the back side of the spindle. Put a few bolts in and weld them together. Then put it on the axle tube with some magnets, center it up and blast it on. Not much harder than that. �;)
You could make a third one similar to the one on right, but with a hole the same size as the diameter of the pipe if you really wanted it strong. The left plate would then be sandwiched between the two with holes.























